How to Use
Before first use
Remove any stickers, protective foil or storage cover from the soleplate.
Filling the Tank
Grasp the water tank’s handle with the hand and press the trigger with one finger, then you can take
out of the water tank for filling with water. Open the filler cap and fill the tank with clean water, taking
care not to exceed the MAX water level. After filling, close the cap and return the tank to the iron
base. Ensure it “clicks” into place.
Power up
Plug in the appliance and press the Power switch until the power indicator is illuminated. The low
steam rate indicator will flash. To switch off press and hold the power switch fro 3 seconds, both
the power indicator and low rate steam indicator will be extinguished, and the appliance will be
disconnected from the power supply.
Steam rate control buttons
The steam rate can be selected low, medium or high with the two steam rate control buttons (see
the schematic illustration of Control panel). Whichever is selected, its indicator will flash, after a few
minutes, the indicator will stay on. At this time, the appliance can produce steam, you can use the
steam for ironing.
Temperature dial
Turn the dial to set ironing temperature according to the chart on previous page.
Temperature indicator
When the iron is heating up, the temperature indicator will be illuminated. Once the iron has reached
the selected temperature, it will extinguish. The temperature indicator will be cycled on and off as
the iron maintains the selected temperature during ironing.
Steam release button
After pressing down the Power switch and choosing the desired steam rate, press the steam button
to release steam. Release the steam button to stop the steam - easy!
Low water indicator
If the water in the tank falls below a minimum level, the indicator will be illuminated, following with
two sounds of buzzer, the steam generator stops working. It prompts you to add water to the tank.
Descaling indicator
If the descaling indicator illuminates, it indicates the steam generator needs descaling. When the
system ensures the mineral deposits have been removed, the indicator will be extinguished.
Power save feature
The appliance will automatically switch off if no steam is released from the soleplate within 10
minutes.
Always check first whether a label with ironing instructions is attached to the article.
The iron heats up quicker than it cools down, therefore, you should start ironing the
articles requiring the lowest temperature such as those made of synthetic fibres.
If the fabric consists of various kinds of fibres, you must always select the lowest ironing
temperature to iron the composition of those fibres.
Silk and other fabrics that are likely to become shiny should be ironed on the inner side.
Velvet and other textures that rapidly become shiny should be ironed in one direction
with light pressure applied. Always keep the iron moving at any given moment.
Pure woollen fabrics (100% wool) may be ironed with the iron set a steam position.
Preferably set steam button to the maximum position and use a dry cloth as a mat.
Note
: when ironing woolen fabrics, shining of the fabric may occur. So it is suggested
that you should turn the article inside out and iron the reverse side.
NEVER TOUCH THE SOLEPLATE DURING USE. NEVER DIRECT STEAM AT PEOPLE
OR BODY PARTS
Ironing Tips
wan
designed for life
wan
designed for life
Control Panel
SI4060N.indd 6-7
10/01/2013 17:48
