4
Before initial use
If you are using the kettle for the first time, it is recommended that you clean your kettle before
use by boiling a full kettle of water twice and then discarding the water.
Operation
1. To fill water into the kettle, remove it from the power base and open the lid by press down
the lid button, fill with the desired amount of water to the kettle. Always fill the kettle between
the minimum (0.25L) and maximum (1.5L) marks. Too little water will result in the kettle
switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout
when boiling. Ensure that the lid is firmly in place before connecting the power cord to
the outlet.
2. Close the lid. Position the kettle on the power base in place. Make sure the kettle contact with
the power base completely.
3. Connect the plug into a power outlet. Lift the switch upwards to “I” position and the switch
light illuminates. Then start to boil the water. The kettle will switch off automatically once the
water has boiled and the switch light extinguishes. You can shut off the power by pressing the
switch at any moment during boiling water.
NOTE
：
Ensure that switch is clear of obstructions and the lid is firmly closed. The kettle
will not turn off if the switch is constrained or if the lid is left open.
4. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water may
result in scald, besides, don’t open the lid while the water in the kettle is hot.
5. The kettle will not re-boil until the switch is uplifted. Allow to cool for 15~20 seconds before
reopening to boil water. The kettle may be stored on the power base when not in use.
NOTE
：
Ensure power supply is turned off when kettle is not in use.
Boil-dry protection
Should you accidentally allow the kettle to operate without water, the boil-dry protection will
automatically switch it off. If this should occur, allow the kettle to cool before filling with cold
water and re-boiling.
Care and cleaning
Always disconnect the appliance from the power outlet and leave it to cool down completely
