10
HOW TO USE
•
Place an espresso cup you have prepared on to the drip plate. Make sure the
steam knob is at the “O” position.
•
Connect into power source, press down the ON/OFF button to turn on the
unit. The power indicator (red) will be illuminated.
•
Press down the pump control button
, the pump will pump water. When
there is water flowing out close the pump by pressing the pump control button
again.
•
Make sure the steam button
is in the OUT position and wait for a moment.
The appliance will begin preheating until the coffee indicator (green) illuminates.
This means that the preheating is finished.
•
Press down the pump control button
again, and water will flow out.
•
After water has flowed for 1 minute, press the pump control button
, you
can pour out the water in each container then clean them thoroughly, now you
can start brewing coffee.
•
Note: There may be noise when pumping the water for the first time. This is
normal, as the appliance is releasing the air in the system. After about 20 sec-
onds, the noise will disappear.
PREHEATING
To make a cup of good hot Espresso coffee, it is recommended to preheat the ap-
pliance before making coffee, including the funnel and cup, so that the coffee flavour
will not be influenced by the cold parts.
•
Remove the removable water tank and fill it with desired water, the water level
should be between the “MAX” mark and the “MIN” mark in the tank. Then insert
the tank into the appliance properly.
•
Set coffee filter into porta-filter (no coffee in coffee filter), then put the porta-
filter under the porta-filter dock (see Fig.1), and turn it anti-clockwise until it is
fixed tightly (see Fig.2 and Fig.3).
•
Place an espresso cup you have prepared on removable cup shelf.
•
Connect the appliance to power supply. Make sure the steam knob is at the “O”
position.
•
Press the ON/OFF button
to turn on the unit, the power indicator (red) will
illuminate, make sure the steam button
is in the OUT position.
•
Press down the pump control button
to the lower position. When there
is water flowing out, close the pump immediately by pressing the pump control
button
again to the OUT position. The purpose of the step is to pump the
water from the tank into the housing.
•
When the coffee indicator (green) is illuminated, and you should press down the
pump control button
again, there will be hot water flowing out.
SK22110_IM.indd 10
19/06/2018 11:03
