4
ENGLISH
Operation Guide
Installing Batteries
The Indoor Alarm Receiver and Motion Sensors require batteries. These are necessary
for the devices to be able to receive and transmit active wireless signals. For best
performance, use fresh, high quality alkaline batteries.
Note: We recommend changing the batteries in the receiver and sensors every six months.
Indoor Alarm Receiver
• The Indoor Alarm Receiver requires 3 x AA batteries (not included) to operate.
• To install batteries, slide off the battery cover on the back of the unit to reveal the battery
compartment and then insert batteries matching the polarity (+ and -) markings inside
the battery compartment.
• Replace the battery cover until it clicks into place.
Motion Sensors
• Each motion sensor requires a 9V battery (not included) to operate.
• To install battery, remove the two screws on the back of the motion sensor securing the
battery compartment cover in place using a small Phillips head screwdriver, attach a
battery to the 9V connector and then place the battery into its compartment.
• Replace the battery cover. Ensure that it makes complete contact with the silicone seal
lining the battery compartment. If moisture is able to enter the motion sensor, it will
adversely affect performance dramatically.
Doorbell
• If you need to replace the battery, insert a small flat-head screwdriver into the small
notch on the base of the doorbell and then push against the tab inside to lift the front
cover off.
• Replace with same type of battery (1 x CR2032 battery). Ensure the battery is secured
properly before refitting the front cover.
Placement of the Motion Sensor
The range of the wireless transmission for the Driveway Alert system is dependent on
local environment (i.e., obstructions, weather, signal interferences, etc) and can be up to
approximately 80 meters (around 263 feet) – take this into consideration when selecting
positions for the motion sensors and make sure you test if the location you place the motion
sensor is in range before fitting in place.
The motion sensor, under typical conditions, is
designed to detect people and vehicles moving
within an area of approximately 6 meters (around
20 feet) at a 100° angle from the sensor.
For best coverage and to maximize detection,
place the sensor approximately 2m/6ft off the
ground, pointing on a slightly downwards angle.
6ft/2m
13ft/4m
20ft/6m
100°