AMU Powercon
Program List and Explanations
A-96.250.331 / 230320
45
2.2.2
Miscellaneous
:
2.2.2.1
Case Temp:
Shows the current temperature in [°C] inside the trans
-
mitter.
2.3 Sample
2.3.1
Sample ID
:
Shows the identification assigned to a sample. This
identification is defined by the user to identify the location of the
sample.
Temperature
: Shows the current sample temperature in °C.
(Pt 1000)
: Shows the current temperature in Ohm.
Sample Flow
: Shows the current sample flow in l/h and the raw
value in Hz.
2.4 I/O State
Shows current status of all in- and outputs.
2.4.1/2.4.2
2.5 Interface
Only available if optional interface is installed.
Review programmed communication settings.
3 Maintenance
3.1 Calibration
Follow the commands on the screen. Save the value with the <en
-
ter> key.
3.2 Simulation
To simulate a value or a relay state, select the
alarm relay,
relay 1 and 2
signal output 1 and 2
with the [
] or [
] key.
Press the <Enter> key.
Change the value or state of the selected item with the [
] or
[
] key.
Press the <Enter> key.
Alarm Relay:
Active or inactive.
Relay 1 and 2:
Active or inactive.
Input:
Open or closed.
Signal Output 1 and 2:
Actual current in mA
