12
MAINTENANCE
UNLOCK
LOCK
1. To release the pet tool
plastic upper cap for internal
cleaning, roatate, unlock and
remove the plastic locking
ring as shown.
2. Pull up on the plastic upper
cap of the pet tool as shown.
3. Remove plastic upper cap
and clean, removing pet hair
and debris.
Pet Tool (SC15832N, SC15834N only)
•
Do not clean the vacuum cleaner, components or accessories using petrol or any other
flammable liquid or solvents, etc.
•
Clean only the outside of the vacuum cleaner.
•
Use only a moist cloth and mild detergent for cleaning the vacuum cleaner, components
and accessories.
•
After cleaning, wipe off the moisture on vacuum cleaner, components and accessories
with a dry cloth.
•
Do Not place accessories, tools or components in a dishwasher.
You should check your cleaner’s brush roll and drive belt regularly for wear or damage.
You should also clean the brush and brush ends by removing string, hair and carpet fibres.
These can wrap around the brush and hamper its ability to effectively clean your carpet. Also
remove any debris that has accumulated under the brush cover.
1. Turn off vacuum and unplug from electrical outlet.
2. Place vacuum upside down with brush roll facing upwards.
3. Remove the six screws as shown with a small Phillips screwdriver (see images below).
4. Lift off brush cover.
5. Grasp floor brush at both ends and remove by lifting out.
6. Clean string, hair and other debris from floor brush, motor pulley, and drive belt.
7. Check floor brush for worn areas and replace if needed.
8. Check air passageway for obstructions. Remove debris from this area.
9. When finished cleaning, reposition floor brush and drive belt. Then replace the brush
cover and re-install the six screws.
10. Turn floor brush by hand several times in the direction of the motor pulley. If properly
installed, the drive belt will align itself on floor brush.
Bush Roll
SC15830_32_34_IM.indd 12
14/01/2019 11:16