![Swann 5055322535285 Manual Download Page 7](http://html.mh-extra.com/html/swann/5055322535285/5055322535285_manual_1412508007.webp)
7
GET TO KNOW YOUR VACUUM
Hose
Extension tube
Main brush
Main body
Push for
cord retract
Push for
power on/off
Pull to
extend cord
Remove the
dust tank
Push
Open the dust tank
Remove the
filter cotton
Clean the
filter cotton
Remove
Periodically remove and
clean the filter assembly.
PLEASE NOTE: it must be
COMPLETELY dry before
refitting.
Water inside the vacuum
could cause malfunction.
Remove the
dust tank
Push
Push
1
Dust tank maintenance
Open the dust tank: Gently lift the
dust tank open button, and then lift
up to open the dust tank cover.
Remove the filter cotton for
cleaning: Open the dust tank, remove
the filter cotton and clean it.
Clean the filter cotton
Separate
Filter disassembly and cleaning: Raise the filter and remove the filter cover,
put the filter and its bottom cover under the tap for washing.
Take out the filter
Separate
1. The filter parts can be put back for use only after being cleaned and dried thoroughly.
2. All parts must be properly installed, otherwise it will cause product failure.
3. Water is not allowed to penetrate into the vacuum cleaner electrical components, or otherwise
may cause product failure.
Illustration of the main unit
Pull out the power cord to connect the power
supply:When you see the red mark on the power
cord, do not pull the power cord outward.
Press the ON/OFF button:Control the start
and stop of the vacuum cleaner.
Press the take up button: The power cord
is automatically rolled back into the machine.
1
2
3
Push
2
1
Push
3
Pull
Main Brush.
Step down the pedal of main brush to extend or
retract the bristles. As a general rule: extended for hard floor,
retract for carpeted floors.
Pet Turbo Tool
(SC15812N only) Connect to end of the hose
in place of the Main Brush to make short work of pet hairs etc.
TROUBLESHOOTING
• Empty dust tank and clean the filters.
• Remove anything that may be clogging the tubes or main brush
THE VACUUM MUST BE SWITCHED OFF WHEN REMOVING DEBRIS
Problem
Solution
Motor will not start
Not enough
suction power
• Make sure cleaner is connected to mains supply
SC15810_12_IM.indd 7
15/10/2018 12:14