INSTRUCTION SHEET
PRODUCT:
64687 Sitkka 2 Bike Rack • Page 1 of 3
Swagman • 300 - 1880 Government St. • Penticton, B.C. Canada V2A 7J1 • Phone (250) 490-8883 • Fax (250) 490-8885 • www.swagman.net
REV 28/02/17
Assembly Instructions:
1. Remove main assembly from box. Assemble the main assembly with the main tube (receiver bar) by 2pcs 12.7mm bolts, washers and nuts.
Tighten securely (diagram 1).
2. For easier assembly, insert the main tube into your hitch.
3. 1. Slide the left rack arm through the wheel holder base and onto the “Main” frame.
2. Insert a nut to the wheel holder base from top.
3-1. Tighten the Pan head Allen 8mm bolt to the wheel holder base.
3-2. Install Pan head Allen 8mm bolt, washer and nut with supplied Allen keys. Repeat with the right arm (diagram 2).
4. Install the front and rear wheel trays onto the wheel holder mount (diagram 3). Note: Check the drawing for the correct position of the front
and rear trays. Attach the wheel trays using 2ea 6mm Allen bolts. Note: The front wheel tray bolts are ½” and the rear wheel trays are ¾” long.
DO NOT OVERTIGHTEN.
5. Insert the green TPR wheel tray inserts by lining up the tabs and pulling the insert into position. The tabs are there to aid in pulling the insert
into position.
6. Re-check all bolts to ensure they are tight.
Installing the Rack on to Your Vehicle:
1. Insert the bike rack into the 2” or 1-1/4” receiver. Install the 1/2” threaded locking hitch pin and tighten to 50 ft. lbs. (very tight). Put on the
lock head until it is securely attached.
2. If the rack is used on a 1-1/4” receiver, using a 4mm Allen wrench remove the 2 Allen set screws that holds on the collar (diagram 4).
2
1
3
4
