INSTRUCTION SHEET
PRODUCT:
64701 Patrol Pick Up Rack • Page 1 of 2
Swagman • 300 - 1880 Government St. • Penticton, B.C. Canada V2A 7J1 • Phone (250) 490-8883 • Fax (250) 490-8885 • www.swagman.net
REV 20/07/16
Assembly Instructions:
1. Remove the small cover on the extrusion. Attach two of
the small metal plates onto the fork mount block using
the two 6mm security bolts (diagram 1). Leave the bolts
as loose as possible.
2. Holding the fork mount block, drop the plates into the
cut-out in the extrusion (diagram 2). Slide the fork mount
into the desired position (diagram 3). Use the supplied
wrench to tighten.
3. Repeat with the second fork mount (diagram 4).
Additional fork mounts can be purchased separately.
4. These fork mounts can be moved to a different location by
loosening the two 6mm security bolts, repositioning the
mount and re-tightening. The fork mounts can be installed
on the inner our outer extrusion. NOTE: Keep the special
wrench in a secure place as you will need the wrench to
move the mounts.
Installation:
1. Unlock and open the telescoping bar clamp. Slide the
inner section out so that the end pads can sit on the
bedrail of the truck (diagram 5).
2. Push the telescoping bar clamp down and lock (diagram 6).
3. Rotate the micro adjust knobs until the Patrol PU rack end
pads are securely tightened against the bedrails.
4. Lock the “micro-adjust” knob so that it turns freely without
loosening the pads.
5. Make sure both end pads are tight against the bedrail. If
the end pads are not tight, unlock the “micro adjust knob”
and turn clockwise a couple of turns.
6. Pull the rack back and forth to ensure that the pads do
not slip.
Special mounting instructions if you have
a bed liner:
1. The material used for bed liners is quite slippery and the
end pads do not grip properly.
2. Install one pin into the end pads as shown (diagram 7).
3. You will need to drill a hole in the bed liner at the position
of this pin. Each hole should be equal distance from the
front of the vehicle.
4. Repeat the procedure above ensuring that the pin goes
into the previously drill holes in the bed liner.
3
2
1
4
