Power Swager
7
If insertion is difficult, the following accessories may be
required:
■
Vise blocks (MS-VB-1 for 1/4, 3/8, and 1/2 in. hose
or MS-VB-2 for 3/4 and 1 in. hose)
■
Pusher
■
Vise
■
Rubber mallet
1.
Clamp the vise block slot around the hose, leaving at least
twice the distance of the insertion depth mark exposed.
2.
Insert the end connection into the hose.
3.
Place the pusher over the end connection. (See the
End
Connections and Pushers chart for the correct pusher
ordering number.)
4.
Tap the pusher with the mallet to insert the hose into the
end connection up to, but not past, the insertion depth mark.
2.
Select the correct pusher for the end connection type and
size. (See the
End Connections and Pushers chart for the
correct pusher selection.)
Note: For end connections that do not appear in the chart,
contact your Swagelok sales representative.
3.
Secure the pusher in the swager.
Die Set and Fitting Lubrication
Before the initial swage, apply a light coat of lubricant to the
die halves. Note: The suggested lubricant is
MS-TP-LUBE
.
Hose Size
in.
Die Set
Number
1/4
MS-7R8R-4
3/8
MS-7R8R-6
1/2
MS-7R8R-8
3/4
MS-8R-12
1
MS-8R-16
1
MS-7P-16
!
Caution
Each die set consists of two matching halves, each
of which is stamped with the same identification
number. Failure to use matching die halves may result
in improper swaging, leading to hose failure. Die set
must match appropriate hose series and size.
Selecting Die Sets and Pushers
1.
Select the appropriate matched swaging die sets.
Hose Series
7N, 7R, 8R, 7P
7N, 7R, 8R, 7P
7N, 7R, 8R, 7P
8R, 7P
8R
7P
Improper Insertions
Not inserted enough
Inserted too far
Proper Insertion
6.
Insert the hose into the end connection up to, but not past,
the insertion depth mark. Note: The bottom of the mark
should line up with the edge of the shell.
shell
Summary of Contents for MS-PSR-110
Page 11: ...Power Swager 11 ...
