S3283
BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL
www.swstahl.de
SW-Stahl GmbH
Tel. +49 (0) 2191 / 46438-0
An der Hasenjagd 3
Fax +49 (0) 2191 / 46438-40
D-42897
Remscheid E-Mail:
1. In the case of a drive square with bore hole, the socket must be secured using a steel
pin and rubber ring. If the drive square is fi tted with a spring ring, this must be checked
for suffi cient tension at regular intervals and replaced if necessary. A socket which is not
secured as described in the way described here can become loose from the tool and
cause damage. For this reason, never allow the pneumatic tool to rev up in idling gear if
there is a socket on the drive.
2. Only use sockets which are suitable for impact screwdrivers.
3. The pneumatic tool should only be used for loosening / tightening screws. Damage
resulting from non-observance of these instructions, improper use or manipulation of
the tool is excluded from warranty claims. We reserve the right to make technical
changes.
4. Those operating the pneumatic tools are not allowed to wear loose clothing and
must have long hair tied back. - ACCIDENT HAZARD
5. Always wear ear protection, safety gloves and goggles.
6. Check hose connections for a fi rm fi t. Do not use any damaged pressure hoses.
Damage caused by non-observance of these operation instructions or by improper repairs
is not covered by our guarantee. We reserve the right to make changes in the interest of
technical progress.
Safety instructions
Clé á cliquet pneumatique
12,5 mm (1/2“) Entraînement, 14 - 68 Nm
• Vitesse de rotation:
•
Entraînement:
• Couple de serrage:
• Niveau de pression acoustique:
• Sound level:
• Pression de service:
• Consommation d‘air:
• Vibration:
• Longueur:
• Poids:
150 U/min
12,5 mm (1/2“)
68 Nm
86 dB (A)
94 dB (A)
6,3 bar
113 l/min
2,6 m/s²
256 mm
1,2 kg
