SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
Leverkuser Strasse 65
Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid
E-Mail: [email protected]
S3264
www.swstahl.de
BED
IENUN
GS
AN
LEI
TUNG /
INSTRUC
TI
ON MANU
AL
1.
The power tool shall not be used in potentially explosive atmospheres.
2.
Unexpected tool movement due to reaction forces or breakage of inserted tool or
reaction bar may cause injuries.
3.
Disconnect the air hose before changing or adjusting any inserted tools.
4.
Prevent long hair or loose clothes from drawing in while operate this tool.
5.
Keep your body in well balanced position and always wear gloves to reduce the
risk of crushing caused by torque between a reaction bar and workpiece.
6.
Unexpected direction of inserted tool movement could cause a hazardous
situation.
7.
Slip/Trip/Fall is a major reason of serious injury. Beware of excess hose left on the
walking or work surface and the whipping air hose.
8.
Wearing eye/face protector could reduce the danger to person from high speed
splinters being emitted from this tool in the case of inserted tool failure or emitted
from the workpiece.
9.
Wearing mouth-muff could avoid inhaling dust or handling debris from work
process that can be harmful to your health.
10.
Excessive high air pressure and too much free rotation may speed the wear of
this tool and might cause danger situation.
11.
After working always disconnect the air hose.
ON-OFF DEVICE
The on-off device is of trigger type which is on the contour
of the grip. It is a "hold-to-run" type. This tool stops rotation
within few seconds, after releasing the trigger.
For the sake of safety, place it on a level plate or on hanger
after it completely stops.
RPM REGULATOR
With the speed controller, the desired speed can be adjusted.
Turn to the right causes an increase of speed
Turn to the left causes a decrease of speed
