www.swstahl.de
SW-Stahl GmbH
Tel. +49 (0) 2191 / 46438-0
An der Hasenjagd 3
Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid
E-Mail: [email protected]
03677L
BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL
• Drill out the injector bolt with approx. 600 rpm.
• Then remove the drilling socket and drilling chips (blow out).
• Further procedure as in point „Renewing screw threads“.
ATTENTION:
• It is absolutely necessary to consider the original length of
the fastening screw during drilling, in order not to damage
possibly included water conduits.
• Use a suitable coolant during boring!
Renewing screw threads:
The injector bolt must basically be renewed since it involves ex-
tension bolts. The set includes two injector bolts (K). Refill the set
again as quickly as possible so that you can implement a repair
immediately.
ATTENTION:
Starting torque of the injector bolt: 15 Nm plus 90
degrees.
