Page 32
N2000 Series User Manual
www.svsiav.com
Chapter 2. Installation
Switching and Scaling Options
SWITCHING AND SCALING OPTIONS
SVSi Encoders and Decoders make up a true AV matrix solution. In other words, one input can go to any or
all outputs.
Both Encoders and Decoders have internal scaling capabilities. Keep the following in mind:
•
The input of an Encoder is the video and/or audio signal going into the Encoder.
•
The output of an Encoder is the network stream.
•
The input of a Decoder is the network stream.
•
The output of a Decoder is the digital video and/or audio being transmitted out to the display
device.
Seamless Switching
The N2000 Series supports seamless switching capability if the scalers in the Encoders are all set to the
same resolution and refresh rate. If the scalers are off, all of the
sources
must have the same resolution and
refresh rate.
To get streams onto a Decoder, use the
Video Matrix
tab to route video from an Encoder to a Decoder. This
works seamlessly if the previously mentioned settings are true. All you have to do is click the common cell on
the matrix, and click the
Take
for an example.
Figure 2-12. Seamless Switching Using the Video Matrix
Enabling this cell causes the
Conference Rm
Decoder
to listen
to the
Conference Rm Encoder
.
Click
Take
to
apply
changes.
