Chapter 5: Local control of the equipment
User’s Manual: DT-02 Series
28
3.7
Bandwidth (5, 6, 7 or 8MHz)
To configure the bandwidth of the transmitted signal:
1.
Using Up and Down arrows select line no.7 (Bandwidth) in the SETUP
menu.
2.
Press right button to change the value of this parameter.
Pressing the right arrow the parameter value changes from one option to
another (5, 6, 7 or 8MHz). There is no need to confirm the change.
3.8
TS parameters
The transport stream parameters are configured in the TS parameters
submenu. To get into that menu:
1.
Using Up and Down arrows select line no.8 (TS Parameters) in the setup
menu.
2.
Press right button to access to the different options of this submenu.
Once in the TS submenu, the following parameters are configurable:
Video PID: Video packets identifier
Audio1 PID: Audio1 packets identifier
Audio2 PID: Audio2 packets identifier
Data PID: Data packets identifier
PMT PID: PMT (Program Map Table) information packets identifier
PCR PID: PCR (Program Clock Reference) information packets identifier
Prog. Number: Program number.
To change the value of each of these parameters follow the steps listed
below:
1.
Using Up and Down arrows select the parameter to be change of the TS
parameters menu.
2.
Press right button to be able to modify the value. After pressing this
button the cursor will appear over the first digit of the parameter.
3.
To increase or decrease the digit’s value use Up and Down buttons
respectively.
4.
To change the other digits, press the Left and Right buttons until the
cursor is over the digit to be changed.
5.
When the desired value has been set, press the Right button until the
cursor reaches the last digit and then save the value.
6.
To exit the parameter without saving the changes press repeatedly the
Left arrow until it is over the first digit and then press it again.
3.9
Video options
To configure video options:
1.
Move to line no.9 on the SETUP CONFIGURATION menu
2.
Press Right button to enter a submenu
