ENG
Operation Manual
UP-600 UP-B800
UP-B1000
3
1. SAFETY PRECAUTIONS
Prior to operation be sure to carefully read the safety instructions:
•
If the battery part of the UPS is completely discharged, and the UPS has been out of use for
three and more months, charge the battery to the maximum level.
•
The connected load power shall not exceed the rated power identified in the table of the technical
specifications.
•
Place the UPS in well-ventilated premises with controlled temperature. During operation the tem-
perature of the housing may increase, which is normal.
•
Unplug the UPS from the mains prior to connection/disconnection of the power load cables to reduce
the risk of electric shock.
•
Do not let liquid and foreign objects get inside the device, it can cause short circuit, get out down
the device or electric shock.
•
In case there are signs of improper operation of the device (sparkling, unusual smells, etc.), it is
necessary to turn off the device immediately and disconnect it from the mains
•
It is strictly forbidden to open the device housing – high voltage inside.
In case of any problems occurred, contact the Customer Service. For the list of Customer Service
offices, visit website
www.sven.fi.
Never operate the UPS:
•
in dusty environment or environment containing highly inflammable gas;
•
at temperature higher than 40°C or lower than 5°C;
•
at relative humidity level higher than 90%;
•
in direct sunlight or next to heating elements;
•
in vibration places.
•
outdoors;
•
In case of fire use only powder fire extinguisher, as using water can cause electric shock. Try to
install the UPS in proximity to power supply, in such way it will be easier to unplug the device if nec-
essary.
2. PACKAGE CONTENTS
•
Uninterrupted power supply (UPS) — 1 pc.
•
Operation Manual — 1 pc.
•
Warranty card – 1 pc.
3. TECHNICAL DESCRIPTION
SVEN UP-B600/UP-B800/UP-B1000 models refer to line-interactive uninterrupted power supply
units. These UPS include in lead-acid maintenance-free 12 V batteries. When the UPS is in inverter
mode, current waveform at the output is the regular sinusoidal wave for power supply computers and
monitors. The UPSs are made in a narrow plastic case for installation on a flat surface and equipped
with an automatic voltage stabilizer (AVR), which allows providing correct power supply to consumers
at high or low voltage without switching to battery mode.