ENG
2.1 Multimedia Speaker System
5
Cause
The MSS isn’t connected to the mains outlet.
Power switch is off.
Volume level is set at minimum value.
Improperly connected audio source.
Volume level is set at minimum value.
Large amplitude of the input signal.
Solution
Check the connection.
Turn on the switch.
Adjust the volume control knob.
Connect audio sources correctly.
Adjust the volume control knob.
Turn down the source volume and
MSS volume.
Problem
The MSS doesn’t
turn on.
No sound.
There is too quiet
sound of speakers.
Distortion of
sound.
If none of the above methods can solve the problem, please seek professional advice at your nearest service center.
Never attempt to repair the product yourself.
6. TROUBLESHOOTING
•
Use the 2RCA to 2RCA signal cable (not included) to connect the MSS to a TV, DVD/CD-players. To do
this, use the signal cable to connect
•
To connect the MSS to a TV, DVD/CD-players, use the 2RCA to 2RCA signal cable (not included).
For this at first plug the RCA jacks of the signal cable into input connector AUDIO INPUT of subwoofer
c
, and the other RCA jacks of cable should be plugged into TV or DVD/CD-player audio outputs as
shown in Fig. 2.
•
Plug the power cord
f
(Fig. 1) on the rear panel of the subwoofer into an outlet.
•
Set the master volume to minimum, turn VOLUME
a
counter-clockwise until it stops.
•
Turn the power switch POWER
d
(position ON) on the rear panel of the subwoofer. Power LED will
illuminate.
•
Turn on your audio source.
•
Adjust the master volume level by turning the VOLUME knob
a
. Adjust the subwoofer volume level by
turning the BASS knob
b
. By turning the knobs clockwise master volume level/subwoofer volume level
increases, while by turning counter-clockwise it is reduced.
Notes: If you don’t use MSS for a long time, make sure the device is turned off, check POWER
switch and unplug the power cord. Use the soundcard Line&Out port to improve sound quality.
