ENG
4
Cause
The MSS isn’t connected to a mains outlet.
The power switch is o
ff
.
The volume level is set at minimum value.
Improperly connected audio source.
Large amplitude of the input signal.
The speakers are improperly connected
to the audio source.
Problem
The MSS doesn’t turn on.
No sound or there is too
quiet sound of speakers.
Distortion of sound.
Sound is produced by
one of the channels only.
Solution
Check the connection.
Turn on the switch.
Adjust the volume control knob.
Connect audio sources correctly.
Turn down the source volume
and MSS volume.
Check the connection of
speakers.
6. TROUBLESHOOTING
7. TECHNICAL SPECIFICATIONS
Parameter, measurement unit
Output power (RMS), W
Frequency response, Hz
Speaker diameter, mm
subwoofer
satellites (t midrange)
Power supply, V/Hz
Dimensions (W × H × D), mm
subwoofer
satellites (one satellite)
Weight, kg
Value
36 (22 + 2 × 7)
35 – 20,000
Ø 133
Ø 25 + Ø 75
~220/50
156 × 282 × 230
95 × 145 × 180
5.5
Notes. Technical speci
fi
cations given in this table are supplemental information and cannot
give occasion to claims. Technical speci
fi
cations and package contents are subject to
change without notice due to the improvement of SVEN production.
•
Before making any connections, make sure the MSS is switched o
ff
. Connect the audio cables
built into the speakers to the OUTPUT jacks: the left speaker to L
i
, the right speaker to R
j
.
•
Insert the mini-jack (Ø 3.5 mm) of the signal cable (included) into the INPUT jack
h
, then con-
nect it to the LINE OUT port of your PC sound card or the output jack of your
МР
3/CD player.
Note: The sound quality is directly affected by correctness and reliability of the connection
of cables. We recommend that you use the cables included with the MSS. Usually, the right
channel (R) is marked in red, and the left channel (L) is marked in white.
•
Adjust the volume to its minimum with the VOLUME knob
e
, then connect the subwoofer to the
mains outlet via the built-in power cord
g
.
•
Switch on the subwoofer with the POWER switch
a
, the power LED
f
will illuminate. Then turn
on your audio source and adjust the subwoofer volume level with the VOLUME knob
e
, the bass
and treble level with the BASS control knob
b
and TREBLE control knob
c
respectively.
•
After using the MSS, mind to shift the POWER switch
a
into the OFF position and unplug the power
cord
g
.
2.1 Multimedia Speaker System
