ENG
8
2.1 Multimedia Speaker System
•
For manual scanning, use buttons TUNE-/+
c
on the remote control (up/down the frequency
range). To save a selected frequency, press SAVE button
r
on the remote control, then using but-
tons
g
and
h
on the front panel of the subwoofer or buttons
d
and
m
on the remote control select
a cell number to save and press the SAVE button once again. When saving, the display
a
will show
the message “Good”.
•
If preset radio stations are available in the memory, you can switch from one to another by short
pressing buttons
g
and
h
on the front panel of the subwoofer or buttons
d
and
m
on the remote
control. You can also enter the frequency or the number of the preset station using numeric pad
buttons
g
on the remote control. The display
a
will show the station number for a short moment
and then its frequency. The radio will tune to the set frequency within 2-3 seconds.
AUX/PC Mode
•
Press INPUT button
d
on the front panel of the subwoofer or INPUT button
a
on the remote
control to switch to the AUX/PC mode. The display
a
will show AUX or PC inscription.
Clock Mode
•
When the MSS is in the ST-BY mode, the display
a
shows the current time. When the system is in
anotrher mode, use the CLOCK button
j
on the remote control to see the time. The current time
will be displayed for 3-5 seconds.
•
To set the current time, enter the ST-BY mode by pressing long INPUT button
d
on the front panel
of the subwoofer or button
q
on the remote control. To enter the time setting mode, press SET
button
l
on the remote control (the corresponding position will start blinking on the display
a
).
Set the required value of hours and minutes directly from the remote control numeric pad or using
buttons
g
,
h
on the front panel of the subwoofer or
d
and
m
on the remote control. To switch
over between setting hours/minutes and to exit the setting mode, press SET button
l
on the
remote control.
ST-BY Mode
•
To enter/exit this mode, press and hold down INPUT button
d
on the front panel of the subwoofer
or button
q
on the remote control. The current time is shown on the display
a
when entering this
mode.
SLEEP Mode
•
The SLEEP mode enables to switch over the device in the ST-BY mode after a lapse of time chosen
by a user. Press button
p
on the remote control to enter the SLEEP mode. To leave the SLEEP mode,
press button
p
on the remote control once again, while there is “0” character on the display.
MUTE Mode
•
To enter the MUTE mode, press button
o
on the remote control. To exit the MUTE mode, press
this button
o
once again.
Note. Due to the constant development of the software, the actual MSS operation may
differ from described in this Manual. The most recent version of the Manual is available on
www.sven.fi.