ENG
8
2.1 Multimedia
Speaker System
Tuner Mode
•
To switch to the Tuner mode, use the MODE
h
button on the front panel or the FM
i
button
on the remote control. The subwoofer display
a
will show the current frequency.
•
To auto scan and memorize the found stations, long press button
i
on the front panel or
the AUTO
m
button on the remote control short. To stop auto scanning, press this button again
before the scanning is over. The display
a
will show the frequency being scanned. When the
channel is being memorized, the display shows its number for a short moment.
•
For manual scanning, use buttons TUNE-/+
d
on the remote control (up/down the frequency
range). To save the selected station, press the SAVE
o
button on the remote control and
then, using buttons
b
and
c
on the front panel or buttons
e
and
l
on the remote control,
assign the station its number and press the SAVE
o
button again. When the station has been
memorized, the display
a
will write «SAU». To delete a station, press and hold the button
REPEAT
h
, display
a
will show «DEL».
•
If preset stations are available in the memory, you can switch from one to another by short
pressing buttons
b
,
c
on the front panel or buttons
e
,
l
on the remote control. You can also
enter the frequency with the remote control numeric pad buttons. The radio will tune to the set
frequency within 2-3 seconds.
AUX Mode
•
To switch to the AUX mode, press the MODE
h
button on the front panel or AUX
j
button
on the remote control, the MSS switched on. The display
a
will show «AUX».
MUTE Mode
•
To enter the MUTE mode, press button
a
on the remote control. The display
a
will write
«MUTE». To exit the MUTE mode, press button
a
on the remote control again.
Note. Due to the constant development of the software, the actual MSS operation may differ
from that described in this manual. The most recent version of the manual is available at
www.sven.fi.
* You might have to enter «0000» code to connect some models of devices via Bluetooth.
** If the item has been already registered in the device list of a source, then the second search
mode activation is not obligatory. Choose the item name and the «connect» command on the
source.
•
If the connection fails, on display
a
the inscription «bt» will have an intermittent glow. It is
necessary to re-put the speaker into the search mode (turn it off and on again)**.
•
While connected to a source, you can control the source player from the remote control or by
using the button on the front panel of the subwoofer.
•
In the Player mode, Equalizer feature is available. To select a preset mode, use the EQ+ and
EQ-
f
button on the remote control.
