Eng
SVEN RC-mini
INSTRUCTION
~
On the remote control, open the battery compartment and place the
provided battery in the right position.
~
Plug the receiver in a power plug, LED will light. And LED flashes one time
per second.
~
Press the ON switch (lasting more than 2 seconds) of your choice on the
remote control. The receiver will then learn the code. When LED flashes
continuously in 2 seconds and go out, it means the receiver learns the code
successfully.
~
Repeat these last two operations for all receivers selecting a different ON
button for each receiver.
~
When power cut or pull out the receiver from a power plug, you should
repeat all the setting above.
OPERATION
~
Plug the device you want to remotely operate in a receiver.
~
Press the corresponding ON or OFF button of the remote control to operate
the plug or
~
Press the direct ON/OFF switch on the receiver to operate the plug.
TROUBLE SHOOTING
~
If a receiver does not react to the remote control operation it can be due to :
~
Low battery in the remote control – Replace it.
~
Distance too large between the remote control and the receiver
~
The pressing time on the buttons must be at least 2 seconds
HOW TO DECODE
~
Press ON/OFF switch on receiver and last for 3 seconds. After the LED
flashes from quickly to once per second, decoding is successful.
~
Press ALL OFF switch on remote control and last for 3 seconds. After the
LED flashes from quickly to once per second, decoding is successful.
TECHNICAL SPECIFICATION
Voltage
230Vac~ / 50Hz
Rating
230Vac / 1000W max.
Max rating energy
55 J
Learning code
More than 1 million
Remote Frequency
433.92MHz
Remote Range
20 Meter
Code setting
Learning
ON/OFF Indicate
LED
Battery Type
L1028 * 1-12V DC Alkaline
USER`S manUal
