WSE201
5
SVAT ELECTRONICS
Now You Can See
OPERATING MODES
The system can be set to operate in one of 2 modes: AUTO or MANUAL. The desired
operating mode can be selected using the buttons on the front panel of the receiver.
Auto
Pressing the AUTO button places the system into auto mode. In this mode, the system
automatically cycles through all active cameras. When a camera detects motion above
the preset level, your television will display the picture from that camera for a few
seconds, and the beeper will sound. To avoid searching the channels that do not have
cameras/transmitters assigned to them, set those corresponding dip switches (located on
the back panel of the receiver) to the OFF position.
The dwell/cycle time (time taken to switch between cameras) is preset to four seconds
and can be adjusted between 2-30 seconds. To adjust the dwell/cycle time, press both
the AUTO and MANUAL buttons at the same time for each second you would like to add.
Release the buttons, and the LED light will flash green for each second that was added
to the dwell time. Increasing the dwell/cycle time past 30 seconds will revert it back to 2
seconds.
Manual
To view a specific camera on the receiver, press the MANUAL button. The receiver will
switch to a different camera each time the MANUAL button is pressed. There are 3 LEDs
on the front of the receiver, and the appropriate LED will light up to indicate the camera
that is active. For example, if you press the manual button to view camera 2, the middle
LED will be lit. To avoid searching the channels that do not have cameras assigned to
them, set those corresponding dip switches (located on the back panel of the receiver) to
the OFF position.
CONNECTING TO A VCR
You can connect a VCR to the system to allow recording of your camera footage. To
connect the receiver to a VCR for recording purposes, use the RCA adapter cable and
connect the appropriate ends to the A/V Out jack on the receiver, and the other
corresponding ends to the audio and video inputs of the VCR.