VIS101-TX
6
OPERATION
Setting the Sensor Sensitivity
Adjusting the sensor’s sensitivity will be necessary depending on how far you are mounting the unit from the area
being monitored. You will also need to adjust the sensitivity if you are getting false alarms, or missing alarms.
1. Remove the battery compartment cover. The sensitivity control is the black switch on the top right side of the
inside of the compartment.
2. Flip the switch to the left to adjust the sensitivity to the low (15ft) setting.
3. Flip the switch to the right to adjust the sensitivity to the high (30ft) setting.
4. Replace the battery compartment cover.
Installation Recommendations
Before installing the sensor unit there are several things you should consider:
• This system is water resistant, not waterproof. Installing it in an area where it is under an awning or covering
is necessary
• Choosing the sensitivity level, either 15 feet or 30 feet, depending on where the sensor will be mounted, the
sensor will detect objects within a 30° angle
• Where the sensor will be placed; must be within a 500 foot line of sight range from the receiver
Hanging the Sensor Unit
You will need an object such as a post or tree to screw the
hanging clip to.
1. Screw the hanging clip to the post using 3 screws.
2. Once you have the hanging clip secured to the post,
hang the sensor unit by first placing the flat edge
under the plastic loop on the battery compartment
cover. Then clip the bottom of the hanging clip
around the bottom of the sensor unit.
3. Fasten the sensor to the bottom of the hanging
clip using the included screw and a phillips head
screwdriver.
4. Once you have hung the sensor it is important
to test its location to ensure you have the proper
sensitivity set.
INSTALLATION
Plastic Loop
Hanging Clip
