11.
Connector Screw and Nut
12.
Inner Pole
13.
Height adjust Know
14.
Outter Pole
15.
Base
16.
Heavy Weight
17.
Fastener
18.
Locking Screw
19.
Grill Locking Screw
Fan Grill Assembly
1.
Fasten the rear grill onto the motor with four screws.
2.
Install the Blade onto the Motor Shaft by tightening the
blade screw.
3.
Centre the Front Grill by aligning the logo on the grill Hub
so it is horizontal and parallel to the floor. Then secure the
Front and Rear Grills completely together by snapping grill
clips into place. Lastly, tighten the grill locking screw at
the bottom of the Rear Grill.
Base Assembly
1.Unscrew the Fasten Ring and Base Locking Nut from the
Stand Assembly.
2. Insert the Stand Assembly through the hole in the center of
the Base and twist into position.
3. Turn the Stand Base upside down with the Stand Assembly
facing the floor and place the Base Weight Support to the
bottom of the Base. Tighten the Base Weight Support to the
Stand Base by the fastener and locking screw.
Finally, connect the assembled fan head and stand with the
connector screw and nuts, ensure it’s strong enough
Operating Instructions:
a) Ensure voltage used corresponds with the voltage indicated.
b) Turn the speed control to selected speeds: 0(off) and speeds1,
2, 3 is Slow, Middle, Fast.
