Svan SVCA420LA, Instruction Manual, Page: 2 / 10

2
You have just acquired a mobile heater, whose technical characteristics are indicated on
the Characteristics Plate affixed to the appliance and
shown in the table below.
Technical Data
– Heater
SVCA420LA
Destiny
– Country
Europe
Type of Gas and
Pressure
Butane, 30mbar
Gas Category I3B
Potency 4,2 kW (Hs)
Consumption in Max
position
0,305 kg/h
Your device is designed to work with "commercial butane" - one of the best-known gases in
Liquefied Petroleum Gases - stored in bottles.
To place the gas bottle, proceed as follows:
Its connection or cylinder exchange must always be carried out far from any flame or
source of ignition.
•
Before placing the gas bottle in the mobile heater compartment, fit the reducer to the
cylinder valve following the installation and safety instructions below:
To place the reducer in the bottle (Fig. 1 and Fig. 2):
1. Check that your heater control knob is in the START (0)
position
2. Confirm that the handle is facing up (fig. 1)
3. Whenever you buy a new bottle, remove the security seal,
opening it by the perforation.
4. Grasp the reducer with both hands. Pull the plastic ring down
with your fingers and insert it into the bottle valve (fig. 1)
5. Push the plastic ring down with your thumbs until you hear a
click, a sign that the reducer is properly connected (fig. 2)
READ THE INSTRUCTIONS CAREFULLY BEFORE PUTTING THE APPLIANCE INTO OPERATION
1. CHARACTERISTICS
This appliance complies with
the provisions of regulation
2016/426/EU on the
approximation of the
legislation of member states
on gas appliances. The
devices were thoroughly
tested before being packaged.
2. PLACEMENT OF THE REDUCER IN THE GAS BOTTLE