Suzuki Wagon R RB310, Supplementary Service Manual

Page: 147 / 254

8G-2 IMMOBILIZER CONTROL SYSTEM
On-Vehicle Service
Registration Procedure of Immobilizer Sys-
tem Components
How to register ignition key
[When using Tech 1A]
For the procedure, refer to “How to register ignition key” in the
same section of the Service manual mentioned in FOREWORD
of this manual.
[When using Tech 2]
1) Perform IMMOBILIZER SYSTEM COMPONENTS REGIS-
TRATION FLOW TABLE.
2) Prepare ignition key(s) with built-in trans-ponder(s) to be reg-
istered to IMMOBILIZER CONTROL MODULE.
3) Connect Tech 2 to DLC with ignition switch at OFF position.
Insert ignition key to be registered into key cylinder and turn
ignition switch to ON (II) position.
4) Select vehicle, “immobilizer” and “Registration” at each
menu screen.
5) Select “Register New Ig Key (Fix code)” to register fix code
from ignition key into immobilizer control module and register
secret key code from immobilizer control module into ignition
key.
In case that secret key has already registered in ignition key,
only fix code will be registered.
Data List
Registration
Trouble Code
Select Vehicle
Select a Mode
SUZUKI -->Other than Notrht America-->
Passenger Car -->WAGON R+(RB310/413)-->
Immobilizer
NOTE:
Whether secret key has already registered or not is
detected by Tech 2 automatically.
It is not necessary to care for secret key registration of
ignition key.
The procedure here after, follow Tech 2 screen and opera-
tor’s manual.
Immobilizer registration menu
F0: Register New Ig Key (Fix Code)
F2: ECM (Regi SKC/PWD)
F1: IMMO Cont (Regi Secret Key Code)