Suzuki Wagon R Plus RB310, Service Manual

Page: 139 / 846

4A-18 FRONT DRIVE SHAFT (G10/M13 ENGINES)
• When installing left oil seal (1) and right oil seal (2) to center
bearing support bracket (3) by using special tools, use care
so that the oil seals installed in proper direction and position
as shown figure.
Special tool
(A): 09913-76010 (For A/T model)
(B): 09951-46010 (For A/T model)
(C): 09944-66020 (For A/T model)
09925-15410 (For M/T model)
Distance
For M/T model
“a”: 8 – 9 mm (0.31 – 0.35 in.)
“b”: 2 – 3 mm (0.08 – 0.12 in.)
For A/T model
“a”: 0 mm (0 in.)
“b”: 0 mm (0 in.)
• Be sure to apply grease to oil seal lip and bearing side space
indicated in figure.
“A”: Grease 99000-25010
• Press-fit center shaft (1) from transaxle side.
Tightening Torque Specification
Fastening part
Tightening torque
N•m kg-m lb-ft
Transfer oil filler/level and drain plugs 21 2.1 15.5
Transmission oil filler/level and drain plugs 23 2.3 17.0
Ball stud bolt 60 6.0 43.5
Tie rod end nut 40 4.0 29.0
Drive shaft nut 175 17.5 127.0
Wheel bolt 95 9.5 69.0
Stabilizer mount bracket bolt 45 4.5 33.0
Center bearing support bolt 50 5.0 37.0