Suzuki SWIFT RS415 2017, Service Manual

Page: 866 / 1257

8A-3 Seat Belts:
Repair Instructions
Front Seat Belt Components
S4RS0A8106001
WARNING:
• Never attempt to disassemble or repair the seat belt pretensioner (retractor assembly). If any
abnormality is found, be sure to replace it with new one as an assembly.
• Be sure to read “Precautions on Service and Diagnosis of Seat Belt: ” before starting to work and
observe every precaution during work. Neglecting them may result in personal injury or
unactivation of the seat belt pretensioner when necessary.
Front Seat Belt Removal and Installation
S4RS0A8106002
WARNING:
• Never attempt to disassemble or repair the
seat belt pretensioner (retractor
assembly). If any abnormality is found, be
sure to replace it with new one as an
assembly.
• Be sure to read “Precautions on Service
and Diagnosis of Seat Belt: ” before
starting to work and observe every
precaution during work. Neglecting them
may result in personal injury or
unactivation of the seat belt pretensioner
when necessary.
Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system. Refer to “Disabling Air Bag
System: in Section 8B”.
3) Remove center pillar lower trim.
4) Disconnect Yellow connector (1) from seat belt
pretensioner (2).
a) Release locking of lock button (3).
b) After unlocked, disconnect to connector.
(a)
(a)
(a)
1
2
3
5
a)
b)
(a)
3
7
(b) 6
2
4
(a)
I4RS0A810002-
1. Upper anchor 4. Buckle 7. Retractor assembly lower mounting bolt
: After tightening lower bolt, tighten upper bolt.
2. Lower anchor 5. Yellow connector (for seat belt pretensioner) : 35 N
˜
m (3.5 kg-m, 25.5 lb-ft)
3. Retractor assembly 6. Retractor assembly upper mounting bolt
: After tightening lower bolt, tighten upper bolt.
: 5.5 N
˜
m (0.55 kg-m, 4.0 lb-ft)