Suzuki SWIFT RS415 2017, Service Manual

Page: 864 / 1257

8A-1 Seat Belts:
Seat Belts
Precautions
Precautions on Service and Diagnosis of Seat
Belt
S4RS0A8100001
WARNING:
If replacing seat belt is necessary, replace
buckle and seat belt assembly together as a
set. This is for the reason of ensuring locking
of tongue plate with buckle. If these parts are
replaced individually, such a locking
condition may become unreliable. For this
reason, SUZUKI will supply only the spare
buckle and seat belt assembly in a set part.
Before servicing or replacing seat belts, refer to the
following precautionary items.
• Seat belts should be normal relative to strap retractor
and buckle portions.
• Keep sharp edges and damaging objects away from
belts.
• Avoid bending or damaging any portion of belt buckle
or latch plate.
• Do not bleach or dye belt webbing. (Use only mild
soap and lukewarm water to clean it.)
• When installing a seat belt anchor bolt, it should be
tightened by hand at first to prevent cross-threading
and then to specified torque.
• Do not attempt any repairs on retractor mechanisms
or retractor covers. Replace defective assemblies with
new replacement parts.
• Keep belts dry and clean at all times.
• If there exist any parts in question, replace such parts.
• Replace belts whose webbing is cut or otherwise
damaged.
• Do not put anything into trim panel opening which seat
belt webbing passes through.
General Description
Seat Belt Construction
S4RS0A8101001
1
1
6
6
5
5
7
6
6
2
2
3
4
I4RS0A810001-
1. Front seat belt assembly (with ELR and pretensioner) 4. Buckle for front seat belt assembly 7. Buckle for rear center seat belt
2. Rear seat belt assembly (with A-ELR) 5. Buckle for rear seat belt assembly
3. Rear center seat belt (with A-ELR) 6. Retractor assembly