Suzuki SWIFT RS415 2017, Service Manual

Page: 822 / 1257

7A-8 Heater and Ventilation:
Installation
Reverse removal procedure noting the following
instructions.
• Connect temperature control cable and airflow control
cable of HVAC control unit to links of HVAC unit.
a. Set airflow selector (1) to “VENT” position and
temperature selector (2) to “MAX COOL” position.
b. Move temperature control lever (1) and airflow
control plate (2) fully to the arrow direction.
c. Fix temperature control inner cable (1) to pin of
temperature control lever and air flow control inner
cable (2) to pin of airflow control plate, and then fix
each outer cable (3) to each cable lock clamp.
NOTE:
After installing control cables, make sure that
control lever and plate move smoothly and
stop at proper position.
• Enable air bag system referring to “Enabling Air Bag
System: in Section 8B”.
• Make sure that airflow outlet changes correctly as
airflow selector is changed.
Blower Speed Selector Inspection
S4RS0A7106011
Check blower speed selector for each terminal to
terminal continuity. If check result does not meet the
following conditions, replace HVAC control unit.
1 2
I4RS0A710016-
1
2
I4RS0A710017-
1
3
2
3
I4RS0A710018-
I H MH
GND
L ML
Position
Terminal
I
OFF
1
2
3
4
L ML MH H GND
I4RS0A710019-