Suzuki SWIFT RS415 2017, Service Manual

Page: 807 / 1257

Power Assisted Steering System: 6C-34
7) Hold rack with soft jawed vise (3) and remove tie-rod
from rack (2).
Installation
1) Install tie-rod (1) to rack (2).
2) Hold rack with soft jawed vise and tighten tie-rod to
specified torque.
Tightening torque
Tie-rod (a): 93 N·m (9.3 kg-m, 67.5 lb-ft)
3) Bend lock washer at 2 places (1) as shown in figure.
4) Apply sealant to gear case groove “A” indicated in
the figure. Position boot properly in grooves of gear
case (or rack side mount) and tie-rod.
After this, check to ensure that boot is free from twist
and dent.
“A”: Sealant 99000–31120
5) Fasten boot with new band and clip securely.
Special tool
(A): 09943–55010
6) Install tie-rod end lock nut and tie-rod end to tie-rod.
Position lock nut to marking (1) made in removal.
NOTE:
When tie-rod was replaced, measure length
“a” on removed tie-rod and use it on new
replacement tie-rod so as to position lock nut
properly.
7) Install steering gear case assembly referring to
“Steering Gear Case Assembly Removal and
Installation: ”.
I4RS0A630033-
I3RM0A630048-
I4RS0A630035-
I3RM0A630050-
I3RM0A630051-
I3RM0A630052-