Suzuki SWIFT RS415 2017, Service Manual

Page: 804 / 1257

6C-31 Power Assisted Steering System:
4) After confirming proper toe, tighten tie-rod end lock
nut to specified torque.
Tightening torque
Tie-rod end lock nut (a): 45 N·m (4.5 kg-m, 32.5
lb-ft)
5) Tighten wheel bolts to specified torque and lower
hoist.
Tightening torque
Wheel bolt: 85 N·m (8.5 kg-m, 61.5 lb-ft)
Tie-Rod End Inspection
S4RS0A6306010
• Inspect for play in ball joint.
• Inspect for play in rack end ball joint.
In either case, if found defective, replace.
Steering Shaft Joint On-Vehicle Inspection
S4RS0A6306012
Check shaft joint for wear, breakage and any other
damage and replace if any defect exists.
Steering Gear Case Assembly Removal and
Installation
S4RS0A6306013
Removal
CAUTION:
Be sure to set front wheels (tires) in straight
direction and remove ignition key from key
cylinder before performing the following
steps; otherwise, contact coil of air bag
system may get damaged.
1) Remove steering joint cover.
2) Make alignment marks (1) on pinion shaft (2) and
joint of steering lower shaft (3) for a guide during
reinstallation.
3) Loosen joint bolt (steering column side) (4) and
remove joint bolt (pinion shaft side) (5) and
disconnect steering lower shaft (3) from pinion shaft
(2).
4) Hoist vehicle and remove both wheels referring to
“Wheel Removal and Installation: in Section 2D”.
5) Remove tie-rod nuts (1) from both steering knuckles.
6) Disconnect both tie-rod ends (1) from knuckles (2),
using puler (3).
I3RM0A630030-
I4RS0A630043-
I4RS0A630026-
5
2
1
5
3
4
3
I4RS0B630013-
I3RM0A630025-