Suzuki SWIFT RS415 2017, Service Manual

Page: 532 / 1257

4E-29 ABS:
Installation
1) Check that no foreign material is attached to sensor
(1) and sensor ring (2).
2) Install it by reversing removal procedure.
Tightening torque
Front wheel speed sensor bolt (a): 25 N·m (2.5
kg-m, 18.0 lb-ft)
Front wheel speed sensor harness clamp bolt
(b): 11 N·m (1.1 kg-m, 8.0 lb-ft)
CAUTION:
Do not pull or twist wire harness more than
necessary when installing front wheel speed
sensor.
3) Check that there is no clearance between sensor
and knuckle.
Front Wheel Speed Sensor Inspection
S4RS0A4506007
• Check sensor for damage.
• Measure resistance of sensor.
Between both terminals (1) of sensor
1.2 – 1.6 k
:
at 20
q
C (68
q
F)
Between sensor terminal (1) and sensor body (2)
Infinity (
f
)
If the check result is not as specified and any
malcondition is found, replace.
Rear Wheel Speed Sensor On-Vehicle
Inspection
S4RS0A4506008
Output Voltage Inspection
1) Disconnect connector from rear wheel speed sensor
referring to Step 1) to 4) of “Rear Wheel Speed
Sensor Removal and Installation: ”.
2) Hoist vehicle.
3) Connect voltmeter between connector (1) terminals.
4) While turning wheel at a speed of approximately 3/4
to 1 1/4 rotation per second, check AC voltage of
sensor.
Output AC voltage at 3/4 to 1 1/4 rotation per
second
53 mV or more
5) If measured voltage is not as specified, check
sensor, ring and their installation conditions.
[A]: OK
[B]: NG
[A] [B]
1 1
(a)
(b)
1
2
I4RS0A450026-
I2RH01450052-
I3RH01450049-