Suzuki SWIFT RS415 2017, Service Manual

Page: 494 / 1257

4C-3 Rear Brakes:
9) Install wheel and tighten wheel nuts to specified
torque.
Tightening torque
Wheel nut (a): 85 N·m (8.5 kg-m, 61.5 lb-ft)
10) Check to ensure that brake drum is free from
dragging and proper braking is obtained. Then
remove vehicle from hoist and perform brake test
(foot brake and parking brake).
Rear Brake Drum and Shoe Inspection
S4RS0A4306003
Brake Drum
Inspect brake drum for wear.
If limit value of drum inner diameter is exceeded or
uneven or stepped wear is excessive, replace drum.
Drum inner diameter “a”
Standard: 200 mm (7.87 in.)
Limit: 202 mm (7.95 in.)
Cracked, Scored or Grooved Drum
A cracked drum is unsafe for further service and must be
replaced. Do not attempt to weld a cracked drum.
Smooth up any slight scores. Heavy or extensive scoring
will cause excessive brake lining wear and it will
probably be necessary to resurface drum braking
surface.
If brake linings are slightly worn and drum is grooved,
drum should be polished with fine emery cloth but should
not be turned.
NOTE:
When drum is removed, visually inspect
wheel cylinder for brake fluid leakage.
Correct leaky point, if any.
Brake Shoe
Measure thickness of brake shoe (1). Also, check
surface of lining for hardening, excessive wear and oil.
Brake shoe thickness ( shoe rim)
Standard: 5.6 mm (0.22 in.)
Limit: 2.6 mm (0.10 in.)
CAUTION:
Never polish lining with sandpaper. If lining is
polished with sandpaper, hard particles of
sandpaper will be deposited in lining and
may damage drum. When it is required to
correct lining, replace it with a new one.
ABS Sensor Ring Removal and Installation (If
Equipped)
S4RS0A4306009
CAUTION:
Do not reuse (reinstall) removed ABS sensor
ring.
Removal
1) Remove brake drum referring to “Rear Brake Drum
Removal and Installation: ”.
2) Remove sensor ring (1) from brake drum (2) using
special tools.
CAUTION:
Pull out sensor ring from brake drum
gradually and evenly. Attempt to pull it out
partially may cause it to be deformed.
Special tool
(A): 09913–75520
(B): 09913–65135
I2RH01430011-
I4RS0A430008-
I2RH01430007-