Suzuki SWIFT RS415 2017, Service Manual

Page: 457 / 1257

Drive Shaft / Axle: 3A-4
10) Remove drive shaft assembly.
11) Remove center bearing support bolts (3) and remove
center bearing support (2) with center shaft (1) from
differential side gear.
Installation
CAUTION:
• Be careful not to damage oil seals and
boots when installing drive shaft.
• Do not hit joint boot with hammer.
Inserting joint only by hands is allowed.
• Make sure that differential side joint is
inserted fully and its snap ring is seated as
it was.
Install drive shaft assembly by reversing removal
procedure and noting the following points.
• Tighten each bolt and nut to the specified torque
referring to “Front Drive Shaft Assembly Components
Location: ”.
• Install stabilizer joint referring to “Front Suspension
Frame, Stabilizer Bar and/or Bushings Removal and
Installation: in Section 2B”.
• Tighten brake hose mounting bolt to specified torque.
Tightening torque
Brake hose mounting bolt: 25 N·m (2.5 kg-m, 18.0
lb-ft)
• Fill transaxle with oil as specified referring to “Manual
Transaxle Oil Change: in Section 5B” or “A/T Fluid
Change: in Section 5A”.
• Check toe setting referring to “Front Wheel Alignment
Inspection and Adjustment: in Section 2B” and adjust
as required.
Front Drive Shaft Disassembly and Assembly
S4RS0A3106007
Disassembly
CAUTION:
• Disassembly of wheel side joint is not
allowed. If any noise or damage exists in it,
replace it as assembly.
• Do not disassemble tripod joint spider. If
any malcondition is found in it, replace it
as differential side joint assembly.
1) Remove differential side (or center shaft side) boot
big band, and then take out joint housing (1).
2) Wipe off grease from shaft and take off snap ring (1)
using special tool.
Special tool
(A): 09900–06107
3
2
1
I2RH01310007-
I2RH01310008-
I3RH0A311009-