24
HEADLIGHT BEAM ADJUSTMENT
The headlight beam can be adjusted vertically if nec-
essary.
To adjust the beam vertically:
Loosen the headlight fitting bolts and move the head-
light up or down as required.
Tighten the bolts.
A: Bolt
ENGINE OIL
Check the engine oil level with the engine oil dipstick.
1. Place the vehicle on level ground.
2. Start the engine and allow it to run for a few minutes
at idling speed.
Stop the engine and wait about three minutes.
3. Remove the oil filler plug.
The engine oil dipstick comes out together with the
oil filler plug.
Wipe the oil from the dipstick with a clean rag.
4. Reinsert the dipstick until the threads touch the filler
neck, but do not screw the plug in.
5. Draw out the dipstick and check the oil level.
The level found on the dipstick should be between
“L” (Low) and “F” (Full) line.
6. If the oil level is below the “L” line, add fresh oil from
the filler hole until the oil level reaches to “F” line.
If the level is above the “F” line, drain oil to “F” line.
7. Reinstall the drain plug and engine oil filler plug.
Tighten them securely.
"
Oil tank drain plug: 12 N·m (1.2 kgf-m)
A: Engine oil filler plug
B: Engine oil dipstick
This vehicle is shipped from factory with the
engine filled with engine oil.
Be sure to check oil level.
F
F
L
L
