Suzuki Liana RH413, Service Manual

Page: 922 / 1302

8A-5 Seat Belts:
Front Seat Belt Removal and Installation
S3RH0A8106002
Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system. Refer to “Disabling Air Bag
System in Section 8B”. (If seat belt pretensioner is
equipped)
3) Remove center pillar lower trim.
4) Disconnect Yellow connector (1) from seat belt
pretensioner (2). (If seat belt pretensioner is
equipped)
a) Release locking of lock slider (3).
b) After unlocked, disconnect to connector.
5) Remove front seat belts from the vehicle.
Installation
Install in reverse order of removal, noting the following.
• Seat belt anchor bolts should have an unified fine
thread (7/16-20 UNF). Under no circumstances
should any different sized or metric screw threads be
used.
• Connect Yellow connector (1) to seat belt
pretensioner securely. (If seat belt pretensioner is
equipped)
a. Connect connector.
b. Lock connector with lock slider (2).
• Enable air bag system. Refer to “Enabling Air Bag
System in Section 8B”. (If seat belt pretensioner is
equipped)
Front Seat Belt Inspection
S3RH0A8106003
WARNING
!
• Never attempt to disassemble or repair the
seat belt pretensioner (retractor
assembly). If any abnormality is found, be
sure to replace it with new one as an
assembly.
• Be sure to read “Precautions on Service
and Diagnosis of Seat Belt”, before
starting to work and observe every
precaution during work. Neglecting them
may result in personal injury or
unactivation of the seat belt pretensioner
when necessary.
• Never measure resistance of pretensioner
or disassemble it. Otherwise, personal
injury may result.
CAUTION
!
If seat belt pretensioner (retractor assembly)
was dropped from a height of 30 cm (1 ft) or
more, it should be replaced.
a
b
2 1
3
I2RH01810003-01
1
1
2
b) a)
I3RH0A810003-01
I2RH01810004-01