Suzuki Liana RH413, Service Manual

Page: 479 / 1302

Brake Control System and Diagnosis: 4A-21
4) [For RH steering vehicle]
a) Remove air cleaner case assembly from vehicle
body.
b) Support engine with support device.
c) Loosen right side engine mounting bolt (1) and
then remove engine mounting bracket nuts (2).
d) Remove right side engine mounting bracket from
timing chain cover and move engine in front
direction.
5) Remove push rod clevis pin and booster mounting
nuts and then remove booster.
Installation
1) [For LH steering vehicle]
Check and adjust clearance between booster piston
rod and master cylinder piston. Refer to “Brake
Booster Inspection and Adjustment”.
2) Check and adjust distance between booster
installation surface (without including packing) and
the center of clevis pin hole referring to “Brake
Booster Inspection and Adjustment”.
3) Install booster (4) to dash panel. Then connect push
rod clevis (5) to pedal arm with clevis pin (2) and clip
(6).
4) Tighten booster mounting nuts (3) to specified
torque.
Tightening torque
Booster mounting nut (a): 13 N·m (1.3 kgf-m, 9.5
lb-ft)
5) [For LH steering vehicle with ABS]
Install brake vacuum pipe to dash panel.
6) [For RH steering vehicle]
a) Install right side engine mounting bracket to
timing chain cover and tighten right side engine
mounting bolt and bracket nuts to specified
torque.
Tightening torque
Right side engine mounting bolt (a): 55 N·m (
5.5 kgf-m, 40.0 lb-ft)
Engine mounting bracket nut (b): 75 N·m (
7.5 kgf-m, 54.5 lb-ft)
b) Remove support device.
c) Install air cleaner case assembly to vehicle body.
7) Install master cylinder assembly to booster referring
to “Master Cylinder Assembly Removal and
Installation”.
8) Fill reservoir with specified fluid.
9) Bleed air from brake system.
10) Check pedal height and play referring to “Brake
Pedal Free Height Inspection” and “Brake Pedal
Play Inspection”.
11) Perform brake test and check each installed part for
fluid leakage.
2
1
I3RH0A410013-01
I3RH0A410014-01
(b)
(a)
I3RH0A410015-01