Suzuki Liana RH413, Service Manual

Page: 212 / 1302

1D-7 Engine Mechanical:
Accelerator Cable Adjustment
S3RH0A1406005
With accelerator pedal depressed fully, check clearance
between throttle lever (1) and lever stopper (2) (throttle
body) which should be within the following specification.
If measured value is out of specification, adjust it to
specification with cable adjusting nut (3).
Clearance between throttle lever and lever stopper
(with pedal depressed fully)
“a”: 0.5 – 2.0 mm (0.02 – 0.07 in.)
Throttle Body Components
S3RH0A1406006
Throttle Body On-Vehicle Inspection
S3RH0A1406007
Check that throttle valve lever (1) moves smoothly.
Throttle Body Removal and Installation
S3RH0A1406008
Removal
1) Disconnect negative cable at battery.
2) Drain cooling system referring to “Cooling System
Flush and Refill in Section 1F”.
3) Disconnect accelerator cable (1) from throttle valve
lever.
4) Disconnect IAT sensor connector and remove air
cleaner assembly with air cleaner outlet hose.
5) Disconnect electric connector from TP sensor (1)
and IAC valve (2).
6) Remove throttle body from intake manifold.
7) Disconnect engine coolant hoses from throttle body.
1. Throttle body 4. Gasket 7. TP sensor screws
2. Gasket 5. Idle air control valve : Tightening torque
3. TP sensor 6. IAC valve screws : Do not reuse.
I2RH0B140017-01
I3RH0A140003-01
I2RH0B140019-01
I2RH0B140019-01
I2RH0B140020-01