9E-13 Glass / Windows / Mirrors:
Rear Door Window Regulator Inspection
S3RH0A9506010
Check the following point:
• Check regulator sliding and rotating parts.
• Check rollers for wear and damage.
• Check wire for damage.
Quarter Window (for Wagon Model) Removal and Installation
S3RH0A9506011
Refer to “Windshield Removal and Installation” as removal and installation procedures are basically the same.
However, note the following.
• Observe the following precautions when applying adhesive (1) along glass (2) edge.
• Adhesive (1) should be applied evenly especially in height.
• Be careful not to damage primer (3).
• Press glass against body quickly after adhesive (1) is applied.
Adhesive amount specification and position for quarter window
Height “a”: 16 mm (0.63 in.)
Width “b”: 9 mm (0.35 in.)
Position “c”: 8 mm (0.31 in.) for glass front section
Position “c”: 10 mm (0.39 in.) for glass rear sections
Position “c”: 12 mm (0.47 in.) for glass bottom section
Width “d”: 14 mm (0.55 in.)
I2RH01950053-01
4. Molding
Summary of Contents for Liana RH413
