Contents of HRT-10 Tool Set
With blade
at the tip
Without blade
at the tip
Caution
This product is a tool set for normal maintenance and reed replace-
ment of SUZUKI 10 hole, chromatic and tremolo harmonicas (with
spot welded reeds only). Do not use it for any other harmonicas or
keyboard harmonicas (Melodion), only aforementioned Suzuki
harmonicas with welded reeds. Also, do not use it for any other
purposes or it could be damaged.
Work in a quiet location with a flat stable surface, and pay close
attention.
Handle with great care to avoid injury (eg. don’ t place your finger
or hand in gap between parts of the tool etc.) Suzuki accepts no
responsibility concerning damage or injury which might occur while
using this product.
The onus of responsibility for using this product correctly is on you, so please follow the downloaded instruc-
tions carefully and you will have no problems.
* This Tool Set does not include replacement reeds, screws
and valves.
They are optional parts to be purchased separately.
⑫
One Bag for Tool Set.
Use it for scraping the base of the reed
for adjusting tuning lower.
Use it for filing the tip of reed for
adjusting the tuning higher.
Use them to remove
and replace covers
and reed plates of
your harmonica.
④
One File with blade at the tip
①
Two screwdrivers of Phillips (+)
and Slotted (-) types
This is a basic tool for maintenance
of harmonicas, which is used for
various reed work.
②
Two Spatulas
Use it to adjust the position of reeds.
③
One Reed Wrench
⑤
One File with Point
⑥
One Punching tool
for the Reedplate
⑦
One Base Part
for wide reedslots
⑧
One Base Part for narrow reedslots
*Stamped ‘N’ on the side
*Stamped ‘W’ on the side
⑨
One Reed Punching Tool
⑩
One Hex Wrench
⑪
One Drill
W
N
W
N
Use for replacing the W and N Base Parts
of the punching tool, and adjusting
their position.
This tool punches a hole
in the reed head.
The higher reeds on
10 hole diatonics have
narrower reeds.
Use N Base Part
for them.
This tool makes an accurate sized and
positioned hole in the reedplate.
This is fitted in the body
of the punching tool in
shipment.
Twist this between your fingers to remove
the burr on the holes in the reed and
reedplate caused by the
punching process.
Tool set for replacing reeds <HRT-10>
Thank you for purchasing the HRT-10 SUZUKI Tool set for replacing reeds. Please check the
contents of this set to make sure everything is enclosed.
The full instruction manual is not included with this tool set,
but can be down-loaded direct from our International Harmonica web site
http://www.suzukiharmonicaworld.com/
You will need to use the special code,
to access the manual.
2-25-12 Ryoke, Naka-ku, Hamamatsu, 430-0852 Japan
