41
OPERATING THE TROLL MODE
(Remote control model: Option Item,
Tiller handle model: Standard Item)
On the remote control model, trolling speed can
be controled to install the optional Troll Mode
switch.
Please contact your authorized Suzuki Marine
Dealer for more information.
NOTE:
To monitor engine speed correctly during the
troll mode operation, Suzuki recommends the
use of the Suzuki 2-scale Monitor Tachometer.
(Remote control model)
System Outline
The “Troll Mode System” is activated by press-
ing the troll mode switch, when the motor is run-
ning at in-gear idle speed. By using this system,
you can set and maintain a desired engine
speed with the control switch in a range from
in-gear idle speed (approx. 800 r/min) to 1200
r/min.
How to use the Troll Mode
Setting the troll mode:
1. Shift into forward or reverse gear and make
sure that the throttle is fully closed (in-gear
idle speed).
2. Press the “UP” or “DN” position of the troll
mode switch, until you hear one beep.
On the remote control model, the REV/TRL
(or REV) lamp on the monitor gauge will
flash indicating that the motor has been set
to the troll mode. The REV/TRL (or REV)
lamp will continue to flash while the motor is
in the troll mode.
Usual scale
Trolling mode scale
NOTE:
The troll mode system will not operate if the
switch is depressed when the handle/shift lever
is in the neutral position.
Adjusting trolling speed:
• When pressing the “UP” switch, one short
beep sounds and the engine speed
increases by 50 r/min.
• When pressing the “DN” switch, one short
beep sounds and the engine speed
decreases by 50 r/min.
NOTE:
• When pressing the “DN” switch at the lower
limit of trolling speed, the engine speed will
not change and three long (0.8 sec.) beeps
will sound.
• When pressing the “UP” switch at the upper
limit of trolling speed, the engine speed will
not change and three long (0.8 sec.) beeps
will sound.
• Shift operation and throttle control remain
operational, even in troll mode.
Cancelling the troll mode:
The troll mode can be cancelled by shifting the
handle/shift lever to the neutral position, or by
increasing the engine speed to 3000 r/min or
more. In both cases, two short (0.1 sec.) beeps
sound when cancelling the troll mode.
Troll mode switch
Tiller handle model
Remote control model
Summary of Contents for DF40A
Page 9: ...9 ...
