Suzuki 86W41 Installation Instructions Download Page 3

Page: 3 / 4

Trouble

Shooting

Harness

Diagram

Trouble

Inspection

Diagnosis

Action

Gauge Sticks

Gauge
Inoperative

A. Backclamp may
be too tight.

1. Slightly loosen nuts
holding backclamp.
Check operation.

1. If gauge works and is
not loose in panel,
continue using gauge.

2. If gauge continues to
stick, replace gauge.

Switch the
instrument power
supply switch on and
off. As power is
supplied the pointer
should jump slightly.

Check wires to
check they were
installed on the
correct terminals and
power is actually
supplied to gauge.

2 If pointer jumps

(indicating power
supplied), check for
signal from engine. If
signal exists, replace
tachometer.

Is power applied to
gauge?

Trouble shooting continued next page.

HN0418 rev A ecr 5609 8/05

Yellow/Red

Green/Orange

Yellow

Black

Gray

HN0397 revA ecr 4452 03/2004

Sync Port

Lights
Sync Stbd

Ground

+14V

Heat shrink tubing

Yellow

Summary of Contents for 86W41

Page 1: ...lear NOTE Indicates potential hazard that could result in death or injury Tools Required Description Part Number Applications Installation Time NOTE Weight Ref Part Number Description QTY Contents 1 2...

Page 2: ...and black bullets are connected to the gray yellow and black wires of the main engine harness 6 Connect the gray extension lead stud connector to the positive post of the synchronizer and plug the bu...

Page 3: ...supplied the pointer should jump slightly Check wires to check they were installed on the correct terminals and power is actually supplied to gauge 2 If pointer jumps indicating power supplied check...

Page 4: ...ffensive appliance Please refer to installation instructions Check for excessive electrical noise caused by an electrical appliance set to close to the gauge i e a magnetic compass a radio transmissio...