Adjustments
SC 303/313
22
013447-101_rev-07
SCAN COIN
9.2
Out-feed Belt
Before making any adjustments to the out-feed belt, ensure that the
belt is clean and is not worn.
Tension Adjustment
The belt tension can be set by adjusting the position of the front
pulley. The spring loaded feed arm keeps a downward pressure on the
belt to prevent coins from slipping.
a) Loosen the nut at the front pulley.
b) Adjust the position of the front pulley to provide the correct belt
tension.
c) Tighten the nut at the front pulley.
Caution!
Do not over tighten the belt as it may cause damage and slow the
speed of the machine.
It is recommended that after adjusting the belt the level adjustment is
checked as described below.
UP
Summary of Contents for SCAN COIN SC 303
