6
1.
Stick the cover through the slot hole in the cabinet. Notice the position of the charging symbol on the
cover and the lip on one side of the snapper. The other side of the snapper is wider.
2.
Place the rubber anti-slip spacer on the backside.
3.
Move the housing with the PCB in a straight line towards the snappers of the cover. Align the housing
side with the groove to the snapper with the lip.
4.
Gently push the snappers inwards and slide the housing onto the snappers. Because of a tight fitting,
some force by hand is needed to fully snap both snappers into the housing.
5.
Finish the assembly by carefully tightening the nut onto the housing towards the rubber anti-slip spacer.
Do no overtighten the nut, use two fingers only.
