0
1.5.1 selecting the units of Measurement
To change the units of measure displayed:
. check the mode indicator. If the mode arrow is not on tIme, press the [mode] button until the arrow is directly below tIme.
. press the [mode] and [select] buttons simultaneously and hold for 3 seconds. field will display “set” momentarily and then
display “unI” (fig. ).
WarNINg: If the user presses the [Select] button (and does not hold in for 3 seconds) while in the “UNI” setting mode, the user will be
in the pressure Sensor calibration. refer to the next sub-section for details.
3. PRESS the [Select] button and hold in for 2 seconds. Located to the right in Field 2, “m” or “ft” will begin to flash.
4. press the [+] button to toggle between “m” and “ft”.
5. at the unit of measure desired, press the [select] button to move to the next unit. located below the “m” or “ft” in field , “mbar”
or “inHg” will begin to flash.
6. press the [+] button to toggle between “mbar” and “inHg”.
7. at the unit of measure desired, press the [select] button to move to the next unit. located at the top right in field (just above
the bubble),
o
c or
o
F will begin to flash.
8. press the [+] button to toggle between °c and °f.
9. at the unit of measure desired, press the [select] button to move to the next unit. located at the top center in field , “m/min” or
“ft/min” will begin to flash.
0. press the [+] button to toggle between “m/min” and “ft/min”.
. at the unit of measure desired, press the [mode] button to accept the changes. press the [mode] button again to return to the
main time mode.
selecting the units of measurement is complete.
note: If the user does not press any button for 1 minute in the setup mode, the display will automatically exit setup.
