Sutron WAD 200, Quick Start Manual, Page: 5 / 36

EN-3
8800-1218 Rev C.
5. Connect and configure the sensor
Go to the “Measurements” tab in LinkComm
Select “Active” to activate measurement “M1” and press “Sensor Template” for pre -defined
sensor setups.
Filter “Lufft” as a manufacturer and “SDI - 12” as interface , and select “WS400 - UMB” as a
model ; Press “Yes” in the next prompt
“Configuration” can be left unchanged
Set Schedule with time as “00:00:00”,
Averaging time “00:00:00” and Interval
as “00:15:
00 ”
6. Setup Alarms, logging interval and a transmission content
Continue in “Measurements” tab in LinkComm
Setup Alarm type “High” with a threshold of 30,
Alarm tx mode as “Tx In and Out” and a
deadband of 2.
Select “Log All” to log all measurements into
memory
Telemetry1’s “Tx data content1” can be left at
“All Logged” to send data measured and logged
after the last transmission.
Alarms are used to send immediate notifications when
sensor readings read a certain threshold; More details can
be found in XLINK 100/500 operating manual
5.1
5.2
5.3
5.5
5.4
6.2
6.3
6.4