13
E N G L I S H •
User's manual
17. Do not vacuum toxic, carcinogenic, com-
bustible or other hazardous materials such as
asbestos, arsenic, barium, beryllium, lead, pes-
ticides or other health endangering materials.
Specially designed units are available for these
purposes.
18. Do not pick up soot, cement, plaster or
drywall dust without cartridge filter and col-
lection filter bag in place. These are very fine
particles that may pass through the foam and
affect the performance of the motor or be ex-
hausted back into the air. Additional collection
filter bags are available.
19. Do not leave the cord lying on the floor
once you have finished the cleaning job. It can
become a tripping hazard.
20. Use special care when emptying heavily
loaded tanks.
21. To avoid spontaneous combustion,empty
tank after each use.
22. The operation of a utility vac can result in
foreign objects being blown into eyes, which
can result in eye damage. Always wear safety
goggles when operating vacuum.
23. STAY ALERT. Watch out what you are do-
ing and use common sense. Do not use vacuum
cleaner when you are tired, distracted or under
the influence of drugs, alcohol or medication
causing diminished control.
FEATURES
KNOW YOUR TOOL
Before attempting to use this wet/dry vac, be-
come familiar with all of its operating features
and safety requirements.
1. CARRYING HANDLE
2. POWER SWITCH
3. LID LATCH
4. VACUUM PORT
5. DUST TANK
6. CASTER DOLLY (x4)
7. ACCESSORY-HOLDER (x4)
(6 & 7; for AS612A, AS510A y AS506A models)
8. DRAINING PORT (Just for AS612A).
UNPACKING AND ASSEMBLING
ATTENTION: Remove contents of carton.
Check each item against the contents list on
the color box.
IMPORTANT: The images shown below are
illustrative and may vary depending on model.
1. Remove the power-
head by pulling the lid
latches in an outward
motion and some
accessories that may
have been shipped in
the tank (fig.1).
2. Attach casters following the instruction and
illustration in this manual.
3. Before replacing power-head, please refer
to Dry Pick-up or Wet Pick-up operation section
in this manual to ensure you have the proper
filters installed for your cleaning operation.
4. Replace power head on the tank by align-
ing tabs with lugs by applying pressure at the
middle point of the clip.
5. Insert flexible hose end with locking-nut into
inlet of tank and tighten. Do not over tighten.
6. Attach the extension
wands to the accessory
end of the hose. Twist
slightly to tighten the
connection (fig.2).
7. Attach one of the cleaning accessories (de-
pending on your cleaning requirements) on
the extension wands. Twist slightly to tighten
the connection.
8. Plug the cord into the wall outlet. Your
cleaner is ready for use.
CASTER/ACCESSORY HOLDER ASSEMBLY
(This apply for AS612A, AS510A & AS506A
models)
1. Invert dust tank,
take the dolly to
align the tank bottom
sinking place. Secure
with screws provided
(fig.3).
Fig.1
Fig.2
Fig.3
2
3
4
5
6
8
7
1
AS503-AS612A manual.indd 13
28/05/15 10:10