Operation
1. Clean all measuring surfaces and scale face.
2. Loosen locking screw and move slider to check that LCD and all function buttons are operating.
3. Select desired units of measure (in/mm).
4. Close slider until outside measuring faces make contact, then press zero button.
5. Measure according to diagrams above.
Specific instructions for product number 310133
• Product 310133 features 3 measuring modes – fractional inches (1/128"), decimal inches to 4 places,
and metric measurements to .01mm.
• This model does not have HOLD function.
• This model does NOT have Auto-off function. Turn off calipers with ON/OFF switch to avoid battery drain.
• Working temperature: 0 – +40°C
• Storage temperature: -10 – +70°C
Maintenance
Keep your caliper clean. Use a non-corrosive, non-abrasive cleaner. A light film of machine oil on the sliding
parts will ensure smooth functioning.
Never apply voltage or use an electric engraver on the caliper. The electronics may be damaged and will
not be covered under warranty.
Abnormal display such as flashing digits, no digits etc., indicates a weak or spent battery. To replace
battery, simply slide battery cover in direction of arrow and replace. Use model SR44 or equivalent.
Positive side of battery must face up.
Please note your caliper was shipped with 2 batteries. We recognize the batteries in the unit may not be
fresh by the time it reaches the consumer. If the batteries in your unit are spent, replace them with the
spares. A spent battery is not a warranty item.
Troubleshooting
Trouble
Possible Causes
Solutions
Flashing digits
Low voltage
Replace battery
No display
1. Low voltage
2. Poor contact
1. Replace battery
2. Clean and adjust battery seat
