Shakespeare Stream Marine Wireless Booster Kit
Shakespeare Stream Marine Wireless Booster Kit
6
Installation
» 1
Mounting surface with drilled hole, wide
enough in diameter to allow both cable
and connector to pass through
FME connector
2
1
N connector
3
» 4
Cable passes through
ferrule, connecting top
end N-connector to the
antenna and sending the
open FME connector
down through mounting
surface
1
Mounting Surface
2
FME Connector
N Connector
3
4
5
» 2
Base Mount (screws
not provided) mounts
directly to mounting
surface
» 3
Ferrule connects to base mount
» 5
Antenna secures in place onto
ferrule
sTep 2. mounT ouTside anTenna
Choose a location for the outside antenna. The location should be:
•
At least a 12-inches from obstructions and other radiating elements, such as a radio antenna.
•
As high as possible and oriented vertically
•
At minimum, 3 ft. away from the location of the helm antenna.
PLEASE REFRAIN FROM MAKING ANY PERMANENT STRUCTURE CHANGES (SUCH AS DRILLING ANY
HOLES) OR PERMANENTLY SECURING BOOSTER COMPONENTS UNTIL INSTALLATION IS COMPLETE AND
THE SYSTEM HAS BEEN TESTED.
Once you have identified optimal mounting location that meet the requirements listed above, determine
the necessary route that cable will take from the from within your center console to outside antenna,
considering any necessary accommodations before proceeding.
We recommend mounting the antenna to an appropriate surface through which a hole may be drilled and
the cable may pass. However, if this is not possible, an alternative mounting solution is available that allows
cable to exit through the ferrule. See below diagram for assembly and installation.
* Note: The outside antenna must not be collocated or operating with any other antenna or booster.
